Service Manual

Removing the right-I/O bracket

WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway

and follow the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the

steps in After working inside your Edge Gateway. For more safety best practices, see the Regulatory Compliance home

page at www.dell.com/regulatory_compliance.

Prerequisites

1. Remove the top cover.

2. Remove the antenna-cable bracket.

3. Remove the right-I/O cover.

Procedure

1. Remove the screw (M3x10) that secures the right-I/O bracket to the system board.

2. Slide and release the tabs on the right-I/O bracket from the system board.

3. Lift the right-I/O bracket o the system board.