Service Manual

18
Replacing the status-light lens
WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway
and follow the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the
steps in After working inside your Edge Gateway. For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.
Procedure
1. Place the status-light lens on the rubber gasket.
2. Slide the left-I/O cover to the system base.
Post-requisites
1. Replace the left-I/O bracket.
2. Replace the antenna-cable bracket.
3. Replace the front cover.
29