Service Manual

Removing the status-light lens

WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway

and follow the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the

steps in After working inside your Edge Gateway. For more safety best practices, see the Regulatory Compliance home

page at www.dell.com/regulatory_compliance.

Prerequisites

1. Remove the front cover.

2. Remove the antenna-cable bracket.

3. Remove the left-I/O bracket.

Procedure

1. Slide the left-I/O cover at an angle from the system base.

2. Lift the status-light lens o the left-rubber gasket.