Service Manual

Replacing the front cover

WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway

and follow the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the

steps in After working inside your Edge Gateway. For more safety best practices, see the Regulatory Compliance home

page at www.dell.com/regulatory_compliance.

Procedure

1. Place the front cover into the slots on the system base.

NOTE: Note the orientation of the front cover. Align the notch on the front cover with the slots on the system base

and place the front cover.

2. Turn the system over.

3. Replace the four screws (M3x18) that secure the front cover to the system base.