Users Guide
Table Of Contents
- Dell Edge Gateway 3001 Installation and Operation Manual
- Overview
- System views
- Installing your Edge Gateway
- Safety and regulatory information
- Setting up your Edge Gateway
- Activating your mobile broadband service
- Mounting your Edge Gateway
- Mounting the Edge Gateway using the standard-mount bracket
- Mounting the Edge Gateway using quick-mount bracket
- Attaching the cable control bars to the standard-mount bracket
- Mounting the Edge Gateway on a DIN rail using the DIN-rail bracket
- Mounting the Edge Gateway using the perpendicular mount
- Mounting the Edge Gateway using a VESA mount
- Setting up the ZigBee dongle
- Setting up the operating system
- Windows 10 IoT Enterprise LTSB 2016
- Ubuntu Core 16
- Overview
- Boot up and log in – Remote system configuration
- Updating operating system and applications
- Additional Ubuntu commands
- Ubuntu Network Manager
- Serial ports
- Minicom
- GPIO
- Security
- Watchdog Timer (WDT)
- Cloud LED On/Off
- Global Positioning Systems (GPS)
- Snappy auto update/Autopilot
- Accessing Snappy Store/Snapweb
- Sensors
- Ignition Pin
- System Power Management
- Restoring Ubuntu Core 16
- Flashing a new OS image
- Ubuntu Server
- Overview
- Login to the Edge Gateway using Ethernet Port 1
- Installing or configuring Dynamic Host Configuration Protocol (DHCP) daemon
- Ubuntu Server driver information
- Firmware management on Ubuntu Server
- Configure Watchdog Timer (WDT)
- Trusted Platform Module (TPM)
- Cloud LED On/Off
- Advanced Linux Sound Architecture (ALSA)
- Global Positioning Systems (GPS)
- Serial ports
- GPIO
- Sensors
- Ignition Pin
- System Power Management
- Ubuntu Network Manager
- Restoring Ubuntu Server
- Creating the OS recovery USB flash drive
- Accessing and updating BIOS
- References
- Appendix
- Contacting Dell
4. Place the Edge Gateway on the DIN rail at an angle, and then pull the Edge Gateway down to compress the springs at the
top of the DIN-rail mounting bracket.
5. Push the Edge Gateway towards the DIN-rail to secure the lower clip of the bracket onto the DIN rail.
NOTE: For more information about demounting the DIN-rail, see Demounting DIN rail.
Mounting the Edge Gateway using the perpendicular mount
NOTE: The perpendicular mount is designed for mounting in a DIN-rail only.
NOTE: An open space of 63.50 mm (2.50 in) around the Edge Gateway is recommended for optimal air circulation. Ensure
that the environmental temperature in which the Edge Gateway is installed does not exceed the operating temperature of
the Edge Gateway. For more information about the operating temperature of the Edge Gateway, see the Edge Gateway
Specifications.
1. Align the screw holes on the perpendicular-mount bracket with the screw holes on the Edge Gateway.
Installing your Edge Gateway
41