Users Guide
Table Of Contents
- Dell Edge Gateway 3001 Installation and Operation Manual
- Overview
- System views
- Installing your Edge Gateway
- Safety and regulatory information
- Setting up your Edge Gateway
- Activating your mobile broadband service
- Mounting your Edge Gateway
- Mounting the Edge Gateway using the standard-mount bracket
- Mounting the Edge Gateway using quick-mount bracket
- Attaching the cable control bars to the standard-mount bracket
- Mounting the Edge Gateway on a DIN rail using the DIN-rail bracket
- Mounting the Edge Gateway using the perpendicular mount
- Mounting the Edge Gateway using a VESA mount
- Setting up the ZigBee dongle
- Setting up the operating system
- Windows 10 IoT Enterprise LTSB 2016
- Ubuntu Core 16
- Overview
- Boot up and log in – Remote system configuration
- Updating operating system and applications
- Additional Ubuntu commands
- Ubuntu Network Manager
- Serial ports
- Minicom
- GPIO
- Security
- Watchdog Timer (WDT)
- Cloud LED On/Off
- Global Positioning Systems (GPS)
- Snappy auto update/Autopilot
- Accessing Snappy Store/Snapweb
- Sensors
- Ignition Pin
- System Power Management
- Restoring Ubuntu Core 16
- Flashing a new OS image
- Ubuntu Server
- Overview
- Login to the Edge Gateway using Ethernet Port 1
- Installing or configuring Dynamic Host Configuration Protocol (DHCP) daemon
- Ubuntu Server driver information
- Firmware management on Ubuntu Server
- Configure Watchdog Timer (WDT)
- Trusted Platform Module (TPM)
- Cloud LED On/Off
- Advanced Linux Sound Architecture (ALSA)
- Global Positioning Systems (GPS)
- Serial ports
- GPIO
- Sensors
- Ignition Pin
- System Power Management
- Ubuntu Network Manager
- Restoring Ubuntu Server
- Creating the OS recovery USB flash drive
- Accessing and updating BIOS
- References
- Appendix
- Contacting Dell
Attaching the cable control bars to the standard-mount bracket
1. Mount the Edge Gateway on the wall using the standard-mount bracket or quick-mount bracket.
2. Place the cable control bar on the mounting bracket and secure it to the notch.
CAUTION: Use the top cable control bar only with coaxial cable connections. Do not use with antennas.
3. Align the screw holes on the cable control bar with the screw holes on the mounting bracket.
4. Tighten the six M3x3.5 mm screws that secure the cable control bar to the mounting bracket.
NOTE: Torque the screws at 5±0.5 kilograms-centimeter (11.02±1.1 pounds-inch).
Installing your Edge Gateway 37