Users Guide
Table Of Contents
- Dell Edge Gateway 3001 Installation and Operation Manual
- Overview
- System views
- Installing your Edge Gateway
- Safety and regulatory information
- Setting up your Edge Gateway
- Activating your mobile broadband service
- Mounting your Edge Gateway
- Mounting the Edge Gateway using the standard-mount bracket
- Mounting the Edge Gateway using quick-mount bracket
- Attaching the cable control bars to the standard-mount bracket
- Mounting the Edge Gateway on a DIN rail using the DIN-rail bracket
- Mounting the Edge Gateway using the perpendicular mount
- Mounting the Edge Gateway using a VESA mount
- Setting up the ZigBee dongle
- Setting up the operating system
- Windows 10 IoT Enterprise LTSB 2016
- Ubuntu Core 16
- Overview
- Boot up and log in – Remote system configuration
- Updating operating system and applications
- Additional Ubuntu commands
- Ubuntu Network Manager
- Serial ports
- Minicom
- GPIO
- Security
- Watchdog Timer (WDT)
- Cloud LED On/Off
- Global Positioning Systems (GPS)
- Snappy auto update/Autopilot
- Accessing Snappy Store/Snapweb
- Sensors
- Ignition Pin
- System Power Management
- Restoring Ubuntu Core 16
- Flashing a new OS image
- Ubuntu Server
- Overview
- Login to the Edge Gateway using Ethernet Port 1
- Installing or configuring Dynamic Host Configuration Protocol (DHCP) daemon
- Ubuntu Server driver information
- Firmware management on Ubuntu Server
- Configure Watchdog Timer (WDT)
- Trusted Platform Module (TPM)
- Cloud LED On/Off
- Advanced Linux Sound Architecture (ALSA)
- Global Positioning Systems (GPS)
- Serial ports
- GPIO
- Sensors
- Ignition Pin
- System Power Management
- Ubuntu Network Manager
- Restoring Ubuntu Server
- Creating the OS recovery USB flash drive
- Accessing and updating BIOS
- References
- Appendix
- Contacting Dell
NOTE: Shut down your system before you change the power sources.
11. Replace the dust caps on any unused ports.
12. When setting up the Edge Gateway for the first time, complete the operating system setup.
For more information, see Setting up your operating system.
NOTE:
MAC addresses and the IMEI number are available on the label at the front of the Edge Gateway. Remove the
label at install.
NOTE: The Edge Gateway is shipped with either Windows 10 IoT Enterprise LTSB 2016 or Ubuntu Core 16 operating
system.
NOTE: The default user name and password for Windows 10 IoT Enterprise LTSB 2016 is admin.
NOTE: The default user name and password for Ubuntu Core 16 is admin.
13. Access the BIOS by connecting remotely with the Dell Command | Configure application.
Windows 10 IOT Enterprise LTSB 2016
Click Start > All Programs > Dell > Command Configure > Dell Command | Configure Wizard.
Ubuntu Core 16
Use the dcc.cctk command to access the Dell Command | Configure application.
NOTE:
For more information about using the Dell Command | Configure application, see the Dell Command | Configure
Installation Guide and User's Guide at www.dell.com/dellclientcommandsuitemanuals.
NOTE: For more information about BIOS settings on the Edge Gateway, see Default BIOS settings.
14. Install the Edge Gateway using one of the following mounting options:
NOTE: An open space of 63.50 mm (2.50 in) is recommended around the Edge Gateway for optimal air circulation.
● Standard mount
● DIN rail mount
● Quick mount
● Perpendicular mount
● Cable control bar
● VESA mount
20
Installing your Edge Gateway