Users Guide
Table Of Contents
- Dell Edge Gateway 3001 Installation and Operation Manual
- Overview
- System views
- Installing your Edge Gateway
- Safety and regulatory information
- Setting up your Edge Gateway
- Activating your mobile broadband service
- Mounting your Edge Gateway
- Mounting the Edge Gateway using the standard-mount bracket
- Mounting the Edge Gateway using quick-mount bracket
- Attaching the cable control bars to the standard-mount bracket
- Mounting the Edge Gateway on a DIN rail using the DIN-rail bracket
- Mounting the Edge Gateway using the perpendicular mount
- Mounting the Edge Gateway using a VESA mount
- Setting up the ZigBee dongle
- Setting up the operating system
- Windows 10 IoT Enterprise LTSB 2016
- Ubuntu Core 16
- Overview
- Boot up and log in – Remote system configuration
- Updating operating system and applications
- Additional Ubuntu commands
- Ubuntu Network Manager
- Serial ports
- Minicom
- GPIO
- Security
- Watchdog Timer (WDT)
- Cloud LED On/Off
- Global Positioning Systems (GPS)
- Snappy auto update/Autopilot
- Accessing Snappy Store/Snapweb
- Sensors
- Ignition Pin
- System Power Management
- Restoring Ubuntu Core 16
- Flashing a new OS image
- Ubuntu Server
- Overview
- Login to the Edge Gateway using Ethernet Port 1
- Installing or configuring Dynamic Host Configuration Protocol (DHCP) daemon
- Ubuntu Server driver information
- Firmware management on Ubuntu Server
- Configure Watchdog Timer (WDT)
- Trusted Platform Module (TPM)
- Cloud LED On/Off
- Advanced Linux Sound Architecture (ALSA)
- Global Positioning Systems (GPS)
- Serial ports
- GPIO
- Sensors
- Ignition Pin
- System Power Management
- Ubuntu Network Manager
- Restoring Ubuntu Server
- Creating the OS recovery USB flash drive
- Accessing and updating BIOS
- References
- Appendix
- Contacting Dell
NOTE: In some environments where the Edge Gateway may be installed, a more robust mounting method is required.
For example, for mounting in marine applications, it is recommended to use only the standard— mount bracket. The
recommendation is due to the presence of vibrations unique to the marine environment.
1. Connect an Ethernet cable to Ethernet port one.
2. Connect the antennas depending on the configuration ordered (optional).
NOTE:
The antennas supported in the Edge Gateway vary depending on the configuration ordered. Antennas are
available in the accessory box shipped with the Edge Gateway.
Table 11. Antennas supported in Edge Gateway 3001
Antennas
supported
Signals
3001 Yes Yes Yes Not applicable Yes
NOTE: Use only the supplied antennas or third-party antennas that meet the minimum specifications.
NOTE: Depending on the configuration ordered, some of the antenna connectors may not be present or may be capped.
NOTE: Mobile broadband antenna connector two is for LTE Auxiliary only; it does not support 3G.
3. Insert the antenna into the connector.
NOTE: If you are installing multiple antennas, follow the sequence indicated in the following image.
16 Installing your Edge Gateway