Users Guide

De-mounting from DIN-rail bracket

1. Pull the Edge Gateway down to release from DIN-rail bracket.

2. Lift the Edge Gateway bracket off the DIN rail.

Connecting to the Edge Gateway

Windows 10 IoT Enterprise LTSB 2016

Boot up and login – Remote system configuration

NOTE: Your computer must be on the same subnet as the Edge Gateway.

1. Connect a network cable from Ethernet port one on the Edge Gateway to a DHCP-enabled network or router that provides IP

addresses.

NOTE: The first-time boot to Windows takes about 5 minutes for system configuration. Subsequent boot-ups take about 50

seconds.

2. Using the MAC address provided on the front cover of the Edge Gateway, obtain the IP address through your network’s DHCP server

or through a network analyzer.

3. On the Windows computer, search for Remote Desktop Connection and launch the application.

4. Log in using the IP address.

NOTE: Ignore any certification errors when connecting to your Edge Gateway.

Boot up and login—Static IP system configuration

NOTE: To help set up the Edge Gateway remotely, the static IP address of Ethernet port two on the Edge Gateway is set to these

values at the factory:

• IP address: 192.168.2.1

• Subnet mask: 255.255.255.0

• DHCP server: Not applicable

You can connect your Edge Gateway to a Windows computer that is on the same subnet using a crossover cable.

1. On the Windows computer, search for View network connections in the control panel.

2. In the list of network devices displayed, right-click the Ethernet adaptor that you want to use to connect to the Edge Gateway, then

click Properties.