Owner`s manual

Installing the Display Assembly

1. Place the display assembly in its position on the computer.

2. Route the LVDS cable and the camera cable through the routing channel. Tighten the screws to secure the display

assembly.

3. Connect wireless antennas along their channels and connect them back to their respective wireless modules.

4. Install:

a) palmrest assembly

b) power connector

c) base corner caps

d) base cover

e) display-hinge cover

f) optical drive

g) hard drive

h) keyboard

i) keyboard trim

j) battery

5. Follow the procedures in

After Working Inside Your Computer

Removing the Display Bezel

1. Follow the procedures in

Before Working Inside Your Computer

2. Remove:

a) battery

b) display-hinge cap

c) base cover

d) base corner caps

e) display assembly

3. Pry up along the edges to release the display bezel.