Owner`s manual

5. Disconnect the power-connector cable and remove the screw that secures the power connector to the computer.

Installing the Power Connector

1. Place the power connector in its slot.

2. Connect the power-connector cable and tighten the screw that secures the power connector to the computer.

3. Route the camera cable and the LVDS cable that secures the power connector to the computer.

4. Tighten the screw to secure the power-connector bracket to the computer and connect the camera cable that

secures the power connector to the computer.

5. Install:

a) base cover

b) base corner cap (right)

c) battery

6. Follow the procedures in

After Working Inside Your Computer