Owner`s manual

Installing the Network Connector

1. Align the network connector to its position on the computer.

2. Place the network-connector bracket on the network connector.

3. Tighten the screw to secure the network-connector bracket to the computer.

4. Route the cable through the routing channel.

5. Connect the cable to the system board.

6. Install:

a) base corner cap (left)

b) base cover

c) battery

7. Follow the procedures in

After Working Inside Your Computer

Removing the Coin-Cell Battery

1. Follow the procedures in

Before Working Inside Your Computer

2. Remove:

a) battery

b) base cover

3. Disconnect the coin-cell battery cable, pry the coin-cell battery upward and remove it from the computer.