Users Guide

180 Machine Settings
Network
Level 1 Level 2 Level 3 Description
Wired LAN TCP/IP Boot Method
Chooses the IP method that best suits your needs.
IP Address
Enter the IP address.
Subnet Mask
Enter the Subnet mask.
Gateway
Enter the Gateway address.
IP Boot Tries
Specifies the number of attempts the machine will try to obtain
an IP address when the Boot Method is set to any setting
except Static.
APIPA
Automatically allocates the IP address from the link-local address
range.
IPv6
Enables or disables the IPv6 protocol.
Ethernet -
Chooses the Ethernet link mode.
Wired Status -
Displays Ethernet link status.
MAC Address -
Displays MAC address of the machine.
Set to
Default
-
Restores wired network settings of the internal print server to the
factory settings.
Wired Enable -
Turns the wired interface on or off.
WLAN TCP/IP
Boot Method Chooses the IP method that best suits your needs.
IP Address Enter the IP address.
Subnet Mask Enter the Subnet mask.
Gateway Enter the Gateway address.
IP Boot Tries Specifies the number of attempts the machine will try to obtain
an IP address when the Boot Method is set to any setting
except Static.
APIPA Automatically allocates the IP address from the link-local address
range
*1
.
IPv6 Enables or Disables the IPv6 protocol.
Setup Wizard
- Configures the wireless network settings using the setup wizard.
WPS/AOSS
- Configures the wireless network settings using WPS or AOSS™
method.
WPS w/PIN
Code
- Configures the wireless network settings using WPS with a PIN
code.
WLAN Status
Status Displays wireless Ethernet link status.
Signal Displays the signal condition.
Channel Displays the channel in use when Status is Active.
Speed Displays the connecting speed when Status is Active.
SSID Displays SSID.
Comm. Mode Displays the current Communication Mode.
MAC Address
- Displays MAC address of the machine.
Set to
Default
- Restores wireless network settings of the internal print server to
the factory settings.
WLAN Enable
- Turns the wireless interface on or off.