User's Manual

Information Technology Equipment (ITE), including peripherals, expansion cards, printers,
input/output (I/O) devices, monitors, and so on, that are integrated into or connected to the
system should match the electromagnetic environment classification of the computer
system.
A Notice about Shielded Signal Cables: Use only shielded cables for connecting
peripherals to any Dell™ device to reduce the possibility of interference with radio
communications services. Using shielded cables ensures that you maintain the appropriate
EMC classification for the intended environment. For parallel printers, a cable is
available from Dell™. If you prefer, you can order a cable from Dell™ on the World Wide
Web at www.dell.com.
FCC, Class B
This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the manufacturer's instruction manual, may cause interference
with radio and television reception. This equipment has been tested and found to
comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including interference that may
cause undesired operation.
Notice: The FCC regulations provide that changes or modifications not expressly approved
by Dell Inc. could void your authority to operate this equipment.
These limits are designed to provide reasonable protection against harmful interference in
a residential installation. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference with radio or
television reception, which can be determined by turning the equipment off and on, you are
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the antenna of the radio/television receiver.
• Increase the separation between this equipment and the radio/television receiver.
• Plug the equipment into a different outlet so that the equipment and the radio/television
receiver are on different power mains branch circuits.
• Consult a representative of Dell™ or an experienced radio/television technician for
additional suggestions.
The following information is provided on the device or devices covered in this document
in compliance with FCC regulations: