Owners Manual

4 Remove the mezzanine card.

5 Remove the OCP card.

6 Remove the expansion riser on slot 5.

7 Remove memory modules.

8 Remove heat sinks and processors.

Steps

1 Disconnect all cables from the server board.

2 Remove the securing screws from the server board.

3 Disconnect the cable clip rings.

NOTE: The location of cable clips may dier depending on the models.

Figure 25. Removing server board securing screws

4 Grasp the back of the server board and tilt upward. Do not lift the back of the server board completely to prevent damage to the

components and I/O ports on the front.

CAUTION

: Do not lift the server board by holding a memory module slot, any other connector, or component.

5 Pull the server board back to release the I/O ports from the chassis, and lift the server board out to remove.

6 Place the server board in an antistatic bag.

Installation and Service Manual

Installing and removing server components