Owners Manual
Integrated Devices
You can use the Integrated Devices screen to view and congure the settings of all integrated devices including the video controller,
integrated RAID controller, and the USB ports.
Viewing Integrated Devices
About this task
To view the Integrated Devices screen, perform the following steps:
Steps
1 Turn on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to nish booting, and then restart
your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click Integrated Devices.
Integrated Devices details
The Integrated Devices screen details are explained as follows:
Table 31. Integrated Devices
Option Description
User Accessible USB Ports Enables or disables the USB ports. Selecting All Ports O disables all USB ports. The USB
keyboard and mouse operate during boot process in certain operating systems. After the
boot process is complete, the USB keyboard and mouse do not work if the ports are
disabled.
NOTE: Selecting All Ports O disables the USB management port and also
restricts access to the iDRAC features.
Internal USB Port 1 Enables or disables the internal USB port.
Internal USB Port 2 Enables or disables the internal USB port.
Internal USB Port Enables or disables the internal USB port. This option is set to On or O.
Embedded NIC1 Enables or disables the Embedded NIC1 port. The option is set to Enabled by default.
iDRAC Direct USB Port Enables or disables the internal USB port. This option is set to On or O.
I/OAT DMA Engine Enables or disables the I/OAT option. Enable only if the hardware and software support the
feature.
Embedded Video Controller Enables or disables the Embedded Video Controller option. This option is set to Enabled
by default.
Current State of Embedded Video Controller Displays the current state of the embedded video controller. The Current State of
Embedded Video Controller option is a read-only eld. If the Embedded Video Controller
40 Installation and Service Manual
Pre-operating system management applications