Owners Manual

Next steps
1 Install the NPIO card into hot swappable bay.
2 Complete the procedure listed in After working inside your system.
3 Install any device drivers needed for the card as described in the documentation for the card.
Installing NPIO card in hot swappable bay
Prerequisites
1 Follow the procedure listed in the After working inside your system.
2 Follow the procedure listed in the Before working inside your system section
Steps
1 Remove the screws securing the riser bracket
2 Remove the riser bracket from the chassis.
NOTE: The PCIe bracket is customized for this system. Retain the bracket if replacing a new PCIe card for use with the new
PCIe card.
3 Align the holes on riser board with the holes on riser bracket.
4 Secure the riser board with screws.
Figure 139. Installing the riser board on a bracket
Table 76. Assembly material
Description Quantity Torque (lbs/inch)
#6-32 screw 2 6 ± 0.2
5 Align the NPIO card with the riser bracket and the riser board connector.
6 Insert the NPIO card in the connector on the riser board.
7 Secure the NPIO card with the provided screw.
NOTE
: You must install an expansion card ller cover over an empty expansion slot to maintain Federal Communications
Commission (FCC) certication of the system. The covers also keep dust and dirt out of the system and aid in proper
cooling and airow inside the system.
262 Installing and removing server components