Owners Manual
1 Ensure that you read the Safety instructions.
2 Complete the procedure listed in Before working inside your system.
3 Remove the PCIe card.
1 To install a new server battery, hold the battery with the positive facing up and slide it under the securing tabs.
2 Press the battery into the connector until it snaps into place.
Figure 20. Installing the system battery
1 Install the PCIe card.
2 Complete the procedure listed in After working inside your system.
3 While booting, press F2 to start the System Setup and ensure the battery is operating properly.
4 Enter the correct time and date in the System Setup Time and Date elds.
5 Exit the System Setup.
Hard drive
For more information on hard drives, see the 512e and 4Kn Disk Formats whitepaper and 4K Sector HDD FAQ document at http://
Dell.com/dssmanuals.
All hard drives are connected to the server board through the hard drive backplane. Hard drives are supplied in hot swappable hard drive
carriers that t in the hard drive slots.
CAUTION
: Before attempting to remove or install a hard drive while the system is running, see the documentation for the storage
controller card to ensure that the host adapter is congured correctly to support hot swappable hard drive removal and insertion.
CAUTION: Do not turn o or restart your system while the hard drive is being formatted. Doing so can cause a hard drive failure.
Installing and removing server components 65