Owners Manual

3 Remove the PCIe card.
1 Locate the battery socket, see Jumpers and connectors.
CAUTION: To avoid damage to the battery connector, you must rmly support the connector while installing or removing a
battery.
2 To eject the battery, press rmly on the edge of the positive side of the battery in the direction of the arrow as shown in the gure.
Figure 19. Removing the system battery
1 Install the PCIe card.
2 Complete the procedure listed in After working inside your system.
3 While booting, press F2 to start the System Setup and ensure the battery is operating properly.
4 Enter the correct time and date in the System Setup Time and Date elds.
5 Exit the System Setup.
Installing system battery
WARNING
: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or
equivalent type recommended by the manufacturer. See your safety information for additional details.
CAUTION: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE: Battery is a Field Replaceable Unit (FRU). Only Dell certied service technicians must remove or install system battery.
64 Installing and removing server components