Owners Manual

4 Once the heat sink locks onto the carrier, remove the heat sink and processor assembly from the processor tray.
Figure 16. Removing the processor assembly from the processor tray
5 Align the processor assembly on the server board, until it is seated rmly in place.
6 In the marked order, tighten the retaining screws to secure the processor assembly.
Figure 17. Installing the processor assembly
Table 42. Assembly material
Description Description Quantity Torque (lbs/inch)
CPU HSK screw 2 12 ± 0.2
7 Install the air shroud between the heat sinks. Make sure the air shroud is locked in place.
Installing and removing server components
59