Owners Manual
Table 38. Assembly material
Description Quantity Torque (lbs/inch)
#6-32 screw 2 8 ± 0.5
Power interface board (PIB)
Removing PIB
Prerequisite
1 Ensure that you read the Safety instructions.
About this task
CAUTION: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized is not covered by warranty. Read and follow the safety instructions that came
with the product.
Before attempting to service any part of the Power Interface Board (PIB), make sure the power source and power cables are turned o
and disconnected.
It is not necessary to remove the PIB cover. The following procedure is provided as reference information only.
Steps
1 Make sure the system is turned o. Log in to the interface. The command line interface (CLI) is displayed.
2 Change directory locations to the specied directory as shown in the following gure.
3 Type the command Stop to turn o the system. The turn-o process is fully completed in 2 minutes.
Installation and Service Manual
Installing and removing system components
139