Manualshelf

Owners Manual

ManualsBrandsDell ManualsConverged InfrastructureDSS 7000
919293949596979899100
99
• Press N to navigate to the Lifecycle Controller based restore options.
• Press F10 to restore data from a previously created Hardware Server Profile.
After the restore process is complete, BIOS prompts to restore the system configuration data.
3. Do one of the following:
• Press Y to restore the system configuration data.
• Press N to use the default configuration settings.
After the restore process is complete, the system restarts.
Entering the system Service Tag using System Setup
If you know the system Service Tag, use the System Setup menu to enter the Service Tag.
1. Turn on the system.
2. Press F2 to start the System Setup.
3. Click Service Tag Settings.
4. Enter the Service Tag.
NOTE: You can enter the only when the Service Tag field is empty. Ensure that you enter the
correct Service Tag. Once the Service Tag is entered, it cannot be updated or changed.
5. Click OK.
6. Import your new or existing iDRAC Enterprise license.
For more information, see Integrated Dell Remote Access Controller User's Guide at dell.com/
idracmanuals.
Trusted Platform Module
The Trusted Platform Module (TPM) is used to generate/store keys, protect/authenticate passwords, and
create/store digital certificates. TPM can also be used to enable the BitLocker HDD encryption feature in
Windows Server.
CAUTION: Do not attempt to remove the Trusted Platform Module (TPM) from the system board.
Once the TPM is installed, it is cryptographically bound to that specific system board. Any attempt
to remove an installed TPM breaks the cryptographic binding, and it cannot be re-installed or
installed on another system board.
Installing the Trusted Platform Module
Prerequisites
1. Ensure that you read the Safety instructions.
2. Complete the procedure listed in Before working inside your system.
CAUTION: Do not remove an installed Trusted Platform Module (TPM). Any attempt to remove an
installed TPM from the system board may damage the TPM.
Steps
1. Align the edge connectors on the TPM with the slot on the TPM connector.
2. Insert the TPM into the TPM connector such that the plastic bolt aligns with the slot on the system
board.