Owners Manual

96
Figure 46. Cabling diagram
18-pin power cable and 4-pin power cable 8-pin power cable
8-pin power cable 60-pin FBBI cable
30-pin signal cable 2-pin Blade EN cable (reserved)
SATA 7P cable 4-pin power cable
Mini SAS HDD cable Power button cable
2. Remove the six screws on the system board.
3. Use a hex nut driver to remove the hex nut on the riser support stando and the riser support
stando.
4. Lift the system board away from the server sled.
NOTE: To prevent damage to the system board, ensure that you hold the system board by its
edges only.
CAUTION: Do not lift the system board assembly by holding a memory module, processor, or
other components.