Owners Manual

55
1 screw (10) 2 expansion-card riser module
3 riser card
Figure 21. Jumper on the riser card
1 Jumper J2 (reserved)
Next steps
Complete the procedure listed in After working inside your system.
Related Links
Removing the expansion-card riser module
Installing the expansion-card riser module
Removing an expansion card
Installing a riser card
NOTE: Only supported cards from Dell can be installed in the system.
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the Safety instructions.
2. Complete the procedure listed in Before working inside your system.
3. Remove the expansion-card riser module.
Steps
1. Insert the riser card into the expansion-card riser module until the card is fully seated.
2. Secure the card with the screws.
Next steps
1. Install the expansion cards.
2. Install the expansion-card riser module on the system board.
3. Complete the procedure listed in After working inside your system.