Owners Manual

5. release tab 6. locking notch on the expansion card
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. Install the internal PERC riser on the system board.
3. Install the cooling shroud.
4. Reconnect the disconnected cables to the expansion card(s).
5. If removed, reinstall the dual riser module.
NOTE: If closed, open the expansion card latch on the cooling shroud to support the full length card.
Related references
Safety instructions on page 53
Related tasks
Before working inside your system on page 53
Removing the dual riser module (optional) on page 92
Removing the cooling shroud on page 59
Removing the internal PERC riser on page 94
Removing an expansion card from the internal PERC riser on page 96
Installing the internal PERC riser on page 95
Installing the cooling shroud on page 60
Installing the dual riser module (optional) on page 93
After working inside your system on page 54
Removing an expansion card from the dual riser module
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Disconnect any cables connected to the expansion card.
4. Remove the expansion card riser out of the system.
NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full length card.
Steps
1. For expansion cards:
a. Installed in PCIe slots 3 and 4 of the dual riser module, lift the expansion card lock up.
b. Installed in PCIe slots 1 and 2 of the dual riser module, pull the expansion card lock down and away from the dual riser
module.
2. Pull the expansion card away from the riser.
3. If you want to remove the expansion card permanently, install a metal filler bracket over the empty expansion slot opening
and close the expansion card latch.
4. Close the expansion card lock.
NOTE:
You must install a filler bracket over an empty expansion card slot. The brackets also keep dust and dirt out of
the system and aid in proper cooling and airflow inside the system. The filler bracket is necessary to maintain proper
thermal conditions.
Installing and removing system components 99