Owners Manual

Figure 43. Removing an expansion card on the internal PERC riser
1.
expansion card guide slot on internal PERC riser 2. expansion card
3. internal PERC riser 4. PCIe connector on internal PERC riser card
5. release tab 6. locking notch on the expansion card
Next steps
1. Follow the procedure listed in the After working inside your system section.
2. Install the internal PERC riser on the system board.
3. Install the cooling shroud.
4. If removed, reinstall the dual riser module.
NOTE: If required, open the expansion card latch on the cooling shroud to support the full length card.
5. Reconnect the disconnected cables to the expansion card(s).
Related references
Safety instructions on page 53
Related tasks
Before working inside your system on page 53
Removing the dual riser module (optional) on page 92
Removing the cooling shroud on page 59
Removing the internal PERC riser on page 94
Installing an expansion card into the internal PERC riser on page 98
Installing the internal PERC riser on page 95
Installing the cooling shroud on page 60
Installing the dual riser module (optional) on page 93
After working inside your system on page 54
Installing and removing system components
97