Owners Manual

Related tasks
Before working inside your system on page 53
Removing an expansion card from the internal PERC riser on page 96
Removing the cooling shroud on page 59
Installing the internal PERC riser on page 95
Installing the cooling shroud on page 60
Installing an expansion card into the internal PERC riser on page 98
After working inside your system on page 54
Installing the internal PERC riser
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If connected, disconnect the from expansion card(s).
4. If connected, remove the full length expansion card.
5. Remove the cooling shroud
6. If applicable, install the PERC card on the riser.
Steps
1. Align the guide slot on the internal PERC riser with the guide pin on the chassis.
2. Align the edge connector of the internal PERC riser with the PCIe connector on the system board.
3. Press down to lock the riser bracket to the chassis.
Figure 42. Installing the internal PERC riser
1.
internal PERC riser module 2. guide slot on the internal PERC riser (2)
3. internal PERC riser 4. guide pin on the chassis (2)
Installing and removing system components 95