Owners Manual

Removing the internal PERC riser
Prerequisites
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. If connected, disconnect the cables from the expansion card(s).
4. If required, remove the dual riser module.
5. Remove the cooling shroud.
Steps
Hold the internal PERC riser module by the edges and lift it out of the system.
Figure 41. Removing the internal PERC riser
1.
internal PERC riser module 2. guide slot on the internal PERC riser (2)
3. internal PERC riser 4. guide pin on the chassis (2)
5. PCIe connector on system board
Next steps
1. Install the cooling shroud.
2. If removed, reinstall the dual riser module.
3. Reconnect all disconnected cables.
4. If required, open the expansion card latch on the cooling shroud to support the full length expansion card.
5. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 53
94
Installing and removing system components