Owners Manual

Figure 33. Removing the 2.5 inch internal hard drive cage
1.
internal hard drive cage guide 2. screw
3. hard drive retention screw (8) 4. internal hard drive cage
5. internal hard drive cage guide slot 6. screw hole on chassis
Next steps
1. Install the internal hard drive carrier.
2. Reconnect the FAN1 cable to the power interposer board.
3. If installed, reinstall the PCIe expansion card riser.
4. If disconnected, reconnect the cables to the expansion card(s).
5. Reinstall the cooling shroud.
6. If required, open the expansion card latch on the cooling shroud to support the full length expansion card.
7. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 53
Related tasks
Before working inside your system on page 53
Removing the dual riser module (optional) on page 92
Removing the internal PERC riser on page 94
Removing the cooling shroud on page 59
Removing the (optional) 2.5 inch internal hard drive carrier on page 76
Installing the (optional) 2.5 inch internal hard drive cage on page 83
82
Installing and removing system components