Owners Manual

4. Reinstall the cooling shroud.
5. If required, open the expansion card latch on the cooling shroud to support the full length expansion card.
6. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 53
Related tasks
Before working inside your system on page 53
Removing the cooling shroud on page 59
Removing the (optional) 2.5 inch internal hard drive carrier on page 76
Removing the internal PERC riser on page 94
Installing the internal PERC riser on page 95
Installing the cooling shroud on page 60
After working inside your system on page 54
Removing the (optional) 2.5 inch internal hard drive from the
internal hard drive carrier
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Phillips #2 screwdriver ready.
4. Disconnect the power and data cables from the hard drive.
5. Remove the internal hard drive carrier.
Steps
1. Remove the screws that secure the hard drive to the internal hard drive carrier.
2. Slide the hard drive out of the internal hard drive carrier.
Figure 31. Removing the (optional) 2.5 inch internal hard drive from the internal hard drive carrier
a. screw (8)
b. internal hard drive carrier
c. hard drive
Installing and removing system components
79