Owners Manual

Figure 29. Removing the 2.5 inch internal hard drive carrier
1.
internal hard drive carrier guide 2. internal hard drive carrier
3. handle-lock 4. lock guide
5. hard drive retention screw (8) 6. internal hard drive cage
7. lock guide pin 8. guide slot
Next steps
1. Install the 2.5 inch internal hard drive carrier.
2. Reconnect the power and data cables to the internal hard drives.
3. If removed, install the PCIe expansion card riser.
4. If disconnected, reconnect the cables to the expansion card(s).
5. Reinstall the cooling shroud.
6. If required, open the expansion card latch on the cooling shroud to support the full length expansion card.
7. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 53
Related tasks
Before working inside your system on page 53
Removing the cooling shroud on page 59
Removing the internal PERC riser on page 94
Installing the cooling shroud on page 60
Installing the (optional) 2.5 inch internal hard drive carrier on page 78
After working inside your system on page 54
Installing and removing system components
77