Owners Manual

Related tasks
Before working inside your system on page 53
Removing the cooling shroud on page 59
Removing the dual riser module (optional) on page 92
Removing the internal PERC riser on page 94
Installing memory modules on page 67
Installing the internal PERC riser on page 95
Installing the dual riser module (optional) on page 93
Installing the cooling shroud on page 60
After working inside your system on page 54
Installing memory modules
Steps
1. Locate the appropriate memory module socket.
2. Open the ejectors on the memory module socket outward to allow the memory module to be inserted into the socket.
3. Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the
memory module in the socket.
CAUTION: Do not apply pressure at the center of the memory module; apply pressure at both ends of the
memory module evenly.
NOTE: The memory module socket has an alignment key that enables you to install the memory module in the socket in
only one orientation.
4. Press the memory module with your thumbs until the socket levers firmly click into place.
When the memory module is properly seated in the socket, the levers on the memory module socket align with the levers on
the other sockets that have memory modules installed.
Figure 19. Installing the memory module
a. memory module
b. alignment key
c. memory module socket ejector (2)
Related concepts
System Setup on page 26
Installing and removing system components
67