Owners Manual

Figure 14. Removing the cooling shroud (140 W processor)
a. cooling shroud
Next steps
1. Reinstall the cooling shroud.
2. If removed, reinstall the optional PCIe expansion card riser.
3. If disconnected, connect the cables to the expansion card(s).
4. If required, open the expansion-card latch on the cooling shroud to support the full length expansion card.
5. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 53
Related tasks
Before working inside your system on page 53
Removing the dual riser module (optional) on page 92
Removing the internal PERC riser on page 94
Installing the cooling shroud on page 60
Installing the internal PERC riser on page 95
Installing the dual riser module (optional) on page 93
After working inside your system on page 54
Installing the cooling shroud
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: For proper seating of the cooling shroud in the chassis, ensure that the cables inside the system are routed along
the chassis wall and secured using the cable securing bracket.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the After working inside your system section.
60
Installing and removing system components