Owners Manual

Steps
1. Turn off the system, including any attached peripherals.
2. Disconnect the system from the electrical outlet and disconnect the peripherals.
3. If applicable, remove the system from the rack.
4. Remove the system cover.
Related references
Safety instructions on page 53
Related tasks
Removing the system cover on page 54
After working inside your system
Prerequisites
Follow the safety guidelines listed in the Safety instructions section.
Steps
1. Install the system cover.
2. If applicable, install the system into the rack.
3. Reconnect the peripherals and connect the system to the electrical outlet.
4. Turn on the system, including any attached peripherals.
Related references
Safety instructions on page 53
Related tasks
Installing the system cover on page 55
Recommended tools
You need the following tools to perform the removal and installation procedures:
● Phillips #1 screwdriver
● Phillips #2 screwdriver
● #T15 Torx screwdriver
● Plastic scribe
● Wrist grounding strap
System cover
The system cover protects the components inside the system and helps in maintaining air flow inside the system.
Removing the system cover
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
54 Installing and removing system components