Owners Manual

Figure 79. Screw location on the system board
a. screw (9)
b. system identification button
Next steps
1. Install or connect the following components:
a. internal PERC riser card
b. the expansion card riser(s)
c. heat sink(s) or heat-sink blank(s)
d. processors(s) or processor blank(s)
e. memory modules and memory module blanks
f. cooling fans
g. cooling shroud
h. power supply unit(s)
2. Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall .
3. Follow the procedure listed in the After working inside your system section.
4. Ensure that you:
a. Use the Easy Restore feature to restore the service tag.
b. Update the BIOS and iDRAC versions.
Related references
Safety instructions on page 53
Installing and removing system components
139