Owners Manual

Figure 70. Cabling between the hard drive backplane RAID controller on dual riser module
1.
system board 2. RAID controller on dual riser module
3. SAS A connector on RAID controller 4. SAS B connector on RAID controller
5. backplane 6. SAS B connectors on backplane
7. SAS A connectors on backplane
Next steps
1. Reconnect the data cable(s) and power cable to the hard drive backplane
2. Install all SAS/SATA/SSD hard drives into their original locations.
3. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 53
Related tasks
Before working inside your system on page 53
Removing a hot swappable hard drive carrier on page 68
Installing a hot-swappable hard drive carrier on page 69
After working inside your system on page 54
Installing and removing system components
127