Owners Manual

Figure 66. Installing the system battery
a. positive side of battery
b. socket
Next steps
1. If applicable, install the PCIe expansion card riser.
2. If applicable, connect the required power or data cables to the expansion card(s).
3. Reinstall the cooling shroud.
4. If applicable, open the expansion card latch on the cooling shroud to secure the full length expansion card.
5. Follow the procedure listed in the After working inside your system section.
6. While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
7. Enter the correct time and date in the System Setup Time and Date fields.
8. Exit the System Setup.
Related concepts
System Setup on page 26
Related references
Safety instructions on page 53
Related tasks
Before working inside your system on page 53
Removing the cooling shroud on page 59
Removing the dual riser module (optional) on page 92
Removing the internal PERC riser on page 94
Installing the internal PERC riser on page 95
Installing the dual riser module (optional) on page 93
Installing the cooling shroud on page 60
After working inside your system on page 54
Hard drive backplane
Your 12 hard drive system supports 3.5-inch or 2.5-inch (x12) SAS/SATA backplane.
Installing and removing system components
123