Owners Manual

Figure 52. Installing the optional remote management port card
1.
remote management port card holder 2. remote management port
3. remote management port card 4. screw (2)
5. remote management port card connector on the system
board
Next steps
1. If removed, reinstall the PCIe expansion card riser.
2. If disconnected, connect the cables to the expansion card(s).
3. Reinstall the cooling shroud.
4. If required, open the expansion card latch on the cooling shroud to secure the full length expansion card.
5. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 53
Related tasks
Before working inside your system on page 53
Removing the cooling shroud on page 59
Installing the cooling shroud on page 60
After working inside your system on page 54
Processors and heat sinks
Use the following procedures when:
● Removing and installing a heat sink
● Installing an additional processor
● Replacing a processor
106
Installing and removing system components