Owners Manual

Related references
Safety instructions on page 53
Related tasks
Before working inside your system on page 53
Removing the cooling shroud on page 59
Installing the optional remote management port card on page 105
Installing the cooling shroud on page 60
After working inside your system on page 54
Installing the optional remote management port card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by
your warranty. Read and follow the safety instructions that are shipped with your product.
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Remove the cooling shroud.
NOTE: If applicable, close the expansion card latch on the cooling shroud to release the full length card.
4. If applicable, disconnect the cables from expansion card(s).
5. If applicable, remove the expansion card riser.
Steps
1. Align and insert the tabs on the remote management port card on the slots on the chassis wall.
2. Insert the remote management port card into the connector on the system board.
3. Tighten the screws to secure the remote management port card.
Installing and removing system components
105