Owners Manual

Figure 50. Installing full height and full length expansion card into the dual riser module
1. dual riser module 2. full height and full length expansion card
3. expansion card retention latch 4. full height and full length expansion card latch (on cooling
shroud)
Next steps
1. Install the expansion card riser.
2. If disconnected, connect the required power or data cables to the expansion card.
3. If required, press the expansion card latch on the cooling shroud to support the full length expansion card.
4. Follow the procedure listed in the After working inside your system section.
5. Install any device drivers required for the expansion card as described in the documentation for the card.
Related references
Safety instructions on page 53
Related tasks
Before working inside your system on page 53
Removing the dual riser module (optional) on page 92
Removing the internal PERC riser on page 94
Removing an expansion card from the dual riser module on page 99
Installing the internal PERC riser on page 95
Installing the dual riser module (optional) on page 93
After working inside your system on page 54
Remote management port card (optional)
The remote management port card is used for advanced management of the system.
Removing the optional remote management port card
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
Installing and removing system components 103