Users Guide

Configuring Lifecycle Controller Network Settings

Use this page to configure network settings for a NIC.

1. Start Lifecycle Controller. For more information, see Starting Lifecycle Controller.

2. On the left pane, click Settings.

3. On the Settings pane, click Network Settings.

4. From the NIC Card drop-down menu, select the NIC port that you want to configure.

NOTE: You can use only one NIC at a time to communicate with the network.

5. From the IPV4 Network Settings→ IP Address Source drop-down menu, select one of the following options:

• No Configuration — indicates that the NIC must not be configured.

• DHCP — indicates that the NIC must be configured using an IP address from a DHCP server. If DHCP is selected, a DHCP

IP address is displayed on the Network Settings page.

• Static IP — indicates that the NIC must be configured using a static IP. Type the IP Address Properties — IP Address,

Subnet Mask, Default Gateway, and DNS Address. If you do not have this information, contact your network

administrator.

6. From the IPV6 Network Settings→ IP Address Source drop-down menu, select one of the following options:

• No Configuration — indicates that the NIC must not be configured.

• DHCPv6 — indicates that the NIC must be configured using an IP address from a DHCPv6 server. If DHCPv6 is selected,

a DHCPv6 IP address is displayed on the Network Settings page.

NOTE: While configuring DHCP server with IPv6, the configuration fails if you disable forwarding or advertising

options.

• Static IP — indicates that the NIC must be configured using a static IP. Type the IP Address Properties — IP Address,

Subnet Mask, Default Gateway, and DNS Address. If you do not have this information, contact your network

administrator.

7. Click Enabled and type the VLAN ID and Priority under Lifecycle Controller VLAN Settings to configure the VLAN settings of

a NIC.

You cannot configure the VLAN settlings of the following NICs:

• Emulex SeaHawk-2 (FH) PCIe Adapter

• Emulex SeaHawk-2 (LP) PCIe Adapter

• Emulex Vindicator-2 rNDC

• Emulex Sea Stallion-2 Mezzanine Card

• Emulex Pave Low-2 bNDC

• Emulex SeaHawk-2 (FH) NIC Only PCIe Adapter

• Emulex SeaHawk-2 (LP) NIC Only PCIe Adapter

• Emulex Vindicator-2 NIC Only rNDC

• Emulex Sea Stallion-2 NIC Only Mezzanine Card

• Emulex Pave Low-2 NIC Only bNDC

8. Click Next.

NOTE: If Lifecycle Controller settings are not correctly configured, an error message is displayed.

NOTE: If you are unable to connect to a network, verify the settings. For information about correct network

settings, contact your network administrator.

Lifecycle Controller features

This section provides a brief description about the Lifecycle Controller features and helps you understand how to use the Lifecycle

Controller wizards most effectively. Each feature is a wizard in Lifecycle Controller, which supports the following features:

• Home — Navigate back to the Home page.