Owners Manual

Figure 32. Removing a processor
1.
close first socket-release lever 2. pin-1 indicator of processor
3. processor 4. slot (4)
5. processor shield 6. open first socket-release lever
7. socket 8. socket keys (4)
Next steps
1. Replace the processor(s).
2. Install the heat sink.
3. Reinstall the cooling shroud.
4. Follow the procedure listed in the After working inside your system section.
Related references
Safety instructions on page 66
Related tasks
Before working inside your system on page 67
Removing an expansion card from expansion card riser 2 or 3 on page 106
Removing the cooling shroud on page 74
Removing a heat sink on page 88
Installing a processor on page 93
Installing a heat sink on page 94
Installing the cooling shroud on page 75
Installing an expansion card into the expansion card riser 2 or 3 on page 108
After working inside your system on page 67
92
Installing and removing system components