Owners Manual

Viewing System Setup
To view the System Setup screen, perform the following steps:
Steps
1. Turn on, or restart your system.
2. Press F2 immediately after you see the following message:
F2 = System Setup
NOTE: If your operating system begins to load before you press F2, wait for the system to finish booting, and then
restart your system and try again.
Related concepts
System Setup on page 37
Related references
System Setup details on page 38
System Setup details
The System Setup Main Menu screen details are explained as follows:
Option
Description
System BIOS Enables you to configure BIOS settings.
iDRAC Settings Enables you to configure iDRAC settings.
The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI
(Unified Extensible Firmware Interface). You can enable or disable various iDRAC parameters by using the
iDRAC settings utility. For more information about this utility, see Integrated Dell Remote Access
Controller User’s Guide at Dell.com/idracmanuals.
Device Settings Enables you to configure device settings.
Related concepts
System Setup on page 37
Related tasks
Viewing System Setup on page 38
System BIOS
You can use the System BIOS screen to edit specific functions such as boot order, system password, setup password, set the
RAID mode, and enable or disable USB ports.
Related references
System BIOS Settings details on page 39
Boot Settings on page 40
Network Settings on page 42
System Information on page 48
Memory Settings on page 49
Processor Settings on page 50
SATA Settings on page 52
38
Pre-operating system management applications