Service Manual

4. Connect the smart-card reader FFC to the connector on the USH daughter board.
5. Connect the touchpad buttons FFC and keyboard backlight FFC to the touchpad.
NOTE: For models shipped with a keyboard backlight from the touchpad.
Next steps
1. Install the inner frame.
2. Install the secondary solid-state drive.
3. Install the solid-state drive.
4. Install the interposer board module.
5. Install the CAMM module or long CAMM module or memory module.
6. Install the battery.
7. Install the SIM card.
8. Install the base cover.
9. Follow the procedure in after working inside your computer.
Keyboard
Removing the keyboard
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the SIM card.
4. Remove the battery.
5. Remove the CAMM module or long CAMM module or memory module.
6. Remove the interposer board module.
7. Remove the solid-state drive.
8. Remove the secondary solid-state drive.
9. Remove the heat-sink for integrated graphics or heat-sink for discrete graphics.
10. Remove the inner frame.
11. Remove the system board.
About this task
The figure indicates the location of the keyboard and provides a visual representation of the removal procedure.
84
Removing and installing components