Service Manual

2. Replace the (M2x2) screw to secure the SD card reader to the computer chassis.
3. Connect the LED board FFC and SD card reader FPC to the SD card reader.
Next steps
1. Install the inner frame.
2. Install the long CAMM module.
NOTE: For models shipped with long CAMM module.
3. Install the battery.
4. Install the secondary solid-state drive.
5. Install the primary solid-state drive.
6. Install the base cover.
7. Follow the procedure in after working inside your computer.
System board
Removing the system board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the SIM card.
4. Remove the battery.
5. Remove the CAMM module or long CAMM module or memory module.
6. Remove the interposer board module.
7. Remove the primary solid-state drive.
8. Remove the secondary solid-state drive.
9. Remove the heat-sink for integrated graphics or heat-sink for discrete graphics.
10. Remove the inner frame.
About this task
The figure indicates the location of the system board and provides a visual representation of the removal procedure.
The following image indicates the connectors on your system board:
Removing and installing components
63