Service Manual
Table Of Contents
- Precision 7670 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 7670
- Base cover
- Battery
- SIM card
- Compression Attached Memory (CAMM) module
- Memory modules
- Memory interposer board
- Solid State Drive
- Secondary M.2 solid-state drive
- Heat sink
- GPU card
- GPU power cable
- Power button board
- Power button
- Speakers
- Inner frame
- SD card reader FPC
- SD card reader
- System board
- Coin-cell battery
- Display assembly
- Power-adapter port
- Smart-card reader
- Keyboard
- Palm rest
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
Steps
1. Adhere the SD card reader FPC into its slot on the computer chassis.
2. Connect the SD card reader FPC to its connectors on the SD card reader and system board.
Next steps
1. Install the inner frame.
2. Install the long CAMM module.
NOTE: For models shipped with long CAMM module.
3. Install the battery.
4. Install the secondary solid-state drive.
5. Install the primary solid-state drive.
6. Install the base cover.
7. Follow the procedure in after working inside your computer.
SD card reader
Removing SD card reader
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the base cover.
3. Remove the primary solid-state drive.
4. Remove the secondary solid-state drive.
5. Remove the battery.
6. Remove the long CAMM module.
NOTE: For models shipped with long CAMM module.
7. Remove the inner frame.
60
Removing and installing components