Service Manual
Table Of Contents
- Precision 7670 Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw list
- Major components of Precision 7670
- Base cover
- Battery
- SIM card
- Compression Attached Memory (CAMM) module
- Memory modules
- Memory interposer board
- Solid State Drive
- Secondary M.2 solid-state drive
- Heat sink
- GPU card
- GPU power cable
- Power button board
- Power button
- Speakers
- Inner frame
- SD card reader FPC
- SD card reader
- System board
- Coin-cell battery
- Display assembly
- Power-adapter port
- Smart-card reader
- Keyboard
- Palm rest
- Drivers and downloads
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System-diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
2. Flip the right edge of the SIM card cover to open it.
NOTE: The images that are shown above are of Precision 7770. The same information applies to Precision 7670.
3. Remove the SIM card from the SIM card slot.
Installing the SIM card
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The figure indicates the location of the SIM card and provides a visual representation of the installation procedure.
28
Removing and installing components