Users Guide

Advanced Configuration of the DRAC 5 65
Connecting the DB-9 or Null Modem Cable for the
Serial Console
To access the managed system using a serial text console, connect a DB-9 null
modem cable to the COM port on the managed system. Not all DB-9 cables
carry the pinout/signals necessary for this connection. The DB-9 cable for this
connection must conform to the specification shown in Table 4-11.
NOTE: The DB-9 cable can also be used for BIOS text console redirection.
Configuring the Management Station Terminal
Emulation Software
Your DRAC 5 supports a serial or telnet text console from a management
station running one of the following types of terminal emulation software:
• Linux Minicom in an Xterm
• Hilgraeve’s HyperTerminal Private Edition (version 6.3)
• Linux Telnet in an Xterm
•Microsoft Telnet
Perform the steps in the following subsections to configure your type of terminal
software. If you are using Microsoft Telnet, configuration is not required.
Table 4-11. Required Pinout for DB-9 Null Modem Cable
Signal Name DB-9 Pin
(server pin)
DB-9 Pin
(workstation pin)
FG (Frame Ground) – –
TD (Transmit data) 3 2
RD (Receive Data) 2 3
RTS (Request To Send) 7 8
CTS (Clear To Send) 8 7
SG (Signal Ground) 5 5
DSR (Data Set Ready) 6 4
CD (Carrier Detect) 1 4
DTR (Data Terminal Ready) 4 1 and 6