Users Guide

RACADM Subcommand Overview 303
coredumpdelete
NOTE: To use this command, you must have Clear Logs or Execute Debug
Commands permission.
Table A-8 describes the coredumpdelete subcommand.
Synopsis
racadm coredumpdelete
Description
The coredumpdelete subcommand can be used to clear any currently resident
coredump data stored in the RAC.
NOTE: If a coredumpdelete command is issued and a coredump is not currently
stored in the RAC, the command will display a success message. This behavior is
expected.
See the coredump subcommand for more information on viewing a coredump.
Supported Interfaces
•Local RACADM
• Remote RACADM
• Telnet/SSH/Serial RACADM
fwupdate
NOTE: To use this command, you must have Configure DRAC 5 permission.
NOTE: Before you begin your firmware update, see "Connecting to the Managed
System Through the Local Serial Port or Telnet Management Station (Client System)"
on page 64 for additional instructions.
Table A-8. coredumpdelete
Subcommand Definition
coredumpdelete Deletes the core dump stored in the DRAC 5.