Users Guide

Using the DRAC 5 SM-CLP Command Line Interface 253
PossibleStates The possible states for the sensor
{ "no intrusion","chassis intrusion," "drive
bay intrusion," "I/O card area intrusion,"
"processor area intrusion," "LAN
disconnect," "unauthorized dock," "FAN
area intrusion" } (for the Intrusion
sensor)
{ "absent," "low," "failed," "good" } (for
the Battery sensor)
{ "good," "bad," "unknown" } (for the
Voltage sensor)
{ "Normal," "Others," "Thermal
Protection," "Cooling Capacity changed,"
"Power Capacity changed," "User
Configuration" } (for the Hardware
Performance sensor)
CurrentState Current state reported by the sensor.
ElementName The name of the sensor
OtherSensorTyp
eDescription
If the sensortype property contains a
value of "1" (others), this property gives
additional description about that sensor.
"Chassis intrusion sensor" (for Intrusion
sensor)
"CMOS battery sensor" (for Battery
sensor)
"Hardware performance sensor" (for
Hardware Performance)
EnabledState Indicates if the sensor is enabled or
disabled
1=Enabled (for all sensors)
Table 13-12. Supported Property Names for Intrusion, Battery, Voltage, and Hardware
Performance Sensors
(continued)
Object Property Description